Ankle brace - two adjustable straps and a slim fit in the shoe

Ankle brace - firm, adjustable support that disappears inside your sneaker

A pull-on brace with two Velcro straps that cross over the joint. You set the tension yourself, from light for a walk to firm for a session on the court. The design is slim enough for a regular running shoe.

Why choose an ankle brace?

A firm sleeve brace offers exactly one level of support, which is rarely what you want. With straps, you tighten it for the game and loosen it for the trip home. The reinforced side panels provide support where the joint works hardest.

• Two adjustable straps: set the tension by hand and change it between sessions.
• Reinforced side panels: additional structure along the outer edge for a steadier feel.
• Slim design: flat, approximately 30 x 10 x 3 cm; laced shoes close normally.
• Perforated panels: air flows through the brace, even during extended wear.
• Quick to put on and take off: step in, pull the straps, and you are ready in about ten seconds.

Support you adjust at the door instead of guessing beforehand.

Put on the brace first and position your heel properly before handling the straps. Guide the lower strap over the instep, then the upper strap around the joint; both should be snug, not tight. Rinse it after a warm session and let it dry away from the heater.

Specifications

• Pull-on brace with Velcro straps
• reinforced side supports
• flat dimensions approximately 30 x 10 x 3 cm
• unisex, adjustable tension

Put it on and head into your next session.