Night splint - three adjustable straps and open toe area for nighttime

Night splint - keeps the foot at the set angle from bedtime until morning

A padded cuff for the foot and lower leg that keeps the ankle at a fixed angle during sleep. Three straps adjust the angle and tension, while the toe end remains open. The weight is low enough that the splint does not weigh down the bed covers.

Why choose a night splint?

Anything worn for eight hours must first fit comfortably and then do its job. This splint achieves both by distributing support across a wide shell rather than a narrow strap. Set the angle once and adjust it in small steps over the following nights.

• Three straps: the angle and tension can be adjusted separately and in fine increments.
• Open toe area: the toes remain free and uncovered all night.
• Steel-reinforced shell: holds the set angle instead of giving way during sleep.
• Perforated panels: air flows through the shell, preventing heat from building up under the covers.
• Soft lining: the padded interior rests against the skin without chafing.

Put it on in the evening and remove it when the alarm goes off.

Sit on the edge of the bed, place your heel in the bottom of the shell, and fasten the ankle strap first. Start the first few nights with a shallow angle and gradually increase the tension. In the morning, loosen the straps instead of pulling the splint off in one motion.

Specifications

• Composite fabric shell with steel reinforcement plates
• 37 x 23 cm, lower width 32 cm
• three adjustable hook-and-loop straps
• open toe area
• lightweight construction for nighttime use

Adjust the straps once and leave them that way.