Safety boots - sealed shaft, toe cap and deep tread

Safety Boots - ankle-cut for stability while letting the joint move

An ankle-high work boot with a sealed upper, reinforced toe cap, and a protective layer in the sole. The shaft ends just above the ankle bone and keeps the foot steady on uneven ground without restricting it. The tread is deeply cut for loose and smooth surfaces.

Why choose safety boots?

A tall shaft provides support, but works against you on every ladder and whenever you bend down. The ankle cut keeps your footing stable while allowing the joint to move. On a construction site where you go up and down all day, the difference becomes clear.

• Reinforced toe cap: deflects impacts and distributes them across the front of the boot.
• Sealed upper: keeps splashing water and wet ground out.
• Penetration-resistant sole layer: a barrier against nails and sharp splinters beneath the foot.
• Deep-cut tread: grips loose gravel, wet planks, and uneven ground.
• Precise closure: tightens evenly across the instep and holds the entire layer in place.

Boots for workdays where ladders and mud are part of the same job.

Fasten the closure at the ankle first, then work toward the toes so the heel stays in place. Knock off mud before it dries, as dried grit becomes lodged in the tread. Let the boots dry at room temperature, not next to a heat source.

Specifications

• waterproof sealed upper
• reinforced, impact-resistant toe cap
• penetration-resistant sole layer
• lightweight, shock-absorbing outsole
• ankle-high cut

Set aside a pair for your next job.